Tool To Remove Carpet Tack Strips

Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced.

Tool to remove carpet tack strips.

Roll up the strips and tape them for easy handling. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. Remove worn carpet pad and tack strips. Remove all debris from home and dispose of legally.

Blue hawk 1 in blue tack strip. At those points slide a pry bar under the tack strip. Then tap it with a hammer until the tack strip pops up. The floor itself is in great condition.

Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. Carpet removal costs 1 to 1 50 per square foot including labor cleanup and waste disposal. Then grab the carpet by hand and continue to pull it up along an entire wall. Press the pry bar in order to begin lifting the tack strip.

This will create a small space between the carpet tack strip and the floor. Safety glasses will protect your eyes in case a piece of the tack strip breaks and becomes airborne. Wear gloves to protect your hands from becoming injured on the sharp tacks. Just grab the carpet with pliers and pull.

Gently tap the painter s tool with the hammer until it is underneath the carpet tack strip. Scrap of carpet or heavy cardboard. Once the carpet is removed locate the nails which attach the tack strips to the floor. Find carpet tools accessories at lowe s today.

Detach carpet from tack strip and adjacent surfaces. Roll or fold the strip secure with duct tape and remove it from the room. This equals 48 to 72 per hour because it usually takes 3 hours to remove carpet from a 12 by 12 foot room including extracting the tack strips and staples. Includes planning equipment and material acquisition area preparation and protection setup and cleanup.

For pricing and availability. You ve pulled the carpet up in your living room and you re delighted to find the original hardwood floor beneath. The average hourly rate is 60 per hour so expect to pay 180 in total for a contractor to remove and dispose of 12 by. Use a utility knife with a sharp new blade to cut through the carpet backing.

Cut carpet into haul able pieces. Fold the carpet over for easy cutting and slice it into narrow strips. The problem you face is the tack strips that were used to install the carpeting. Slide the pry bar down to the next nail and repeat until the strip is loose from the floor.